Zebra Technologies Corporation RFID-R110XI-01 Manuel D’Utilisation
112
R110/R170XiIIIPlus User Guide
Routine Maintenance
Clean Interior
To clean the printhead and platen roller, complete these steps:
1. Open the printhead.
2. Remove the labels and ribbon (if loaded).
3. Use Zebra’s Preventative Maintenance kit, part number 47362, or a solution of
2. Remove the labels and ribbon (if loaded).
3. Use Zebra’s Preventative Maintenance kit, part number 47362, or a solution of
90% isopropyl alcohol and 10% deionized water on an applicator to wipe along the print
elements from end to end, as shown in the following illustration. (The print elements are
on the brown strip on the printhead.) Allow a few seconds for the solvent to evaporate.
elements from end to end, as shown in the following illustration. (The print elements are
on the brown strip on the printhead.) Allow a few seconds for the solvent to evaporate.
4. Rotate the platen roller and clean thoroughly with solvent and an applicator.
5. Brush or vacuum any accumulated paper lint and dust away from the rollers.
6. Reload ribbon (if required).
7. Close the printhead.
5. Brush or vacuum any accumulated paper lint and dust away from the rollers.
6. Reload ribbon (if required).
7. Close the printhead.
Caution • The printhead is hot and can cause severe burns. Allow the printhead to cool.
Electrostatic Discharge Caution • Observe proper electrostatic safety precautions when
handling any static-sensitive components such as circuit boards and printheads.
handling any static-sensitive components such as circuit boards and printheads.
1
Applicator
2
Platen roller
3
Printhead print elements
4
Printhead lever
1
2
3
4