Senstar Corporation LM100 Manuel D’Utilisation

1. Hold the luminaire against the fence post as close to the top of the fence as possible without 

making contact with the climb over barrier (minimum 25 mm {1 in.} separation between the 
luminaire and the barbed wire) and mark the locations for the stainless steel post clamps.

2. Wrap the 2 post clamps around the luminaire and fence post to hold the luminaire in place.
3. Tighten the clamps so they fit into the slots on the luminaire’s bracket, and the luminaire is 

perpendicular to the fence line and plumb to the ground.

4. If necessary, adjust the position of the luminaire on the fence post and finish tightening the 

clamps until the luminaire is held securely against the fence.

5. Measure the space between the top of the fence post and the luminaire’s bracket and install 

the remaining luminaires at the same height.

  

Figure 10: Luminaire installation steps 1 & 2

Figure 11: Luminaire installation steps 3 & 4