ZyXEL Communications Corporation AMG1302 Manuel D’Utilisation
Chapter 15 Quality of Service (QoS)
AMG1302-T10A User’s Guide
173
15.2.1 The QoS Settings Summary Screen
Use this screen to display a summary of rules and actions configured for the Device. In the
Advanced > QoS
Advanced > QoS
screen, click the Rule&Action Summary button to open the following screen.
Figure 98
Advanced Setup > QoS > QoS Settings Summary
The following table describes the labels in this screen.
Type of Service
Remarking
Select a type of service to re-assign the priority level to matched traffic.
Available options are: Normal service, Minimize delay, Maximize throughput,
Maximize reliability
and Minimize monetary cost.
DSCP Remarking
Specify a DSCP number between 0 and 63 to re-assign the priority level to matched
traffic.
802.1p Remarking Select a priority level (0 to 7) to re-assign the priority level to matched traffic.
Queue #
Queue #
Specify a Low, Medium, High or Highest queue tag to matched traffic. Traffic assigned
to a higher queue gets through faster while traffic in lower queues is dropped when there
is network congestion.
ADD
Click this to add the rule.
DELETE
Click this to remove the rule.
CANCEL
Click this to restore previously saved settings.
Table 64
Advanced Setup > QoS
LABEL
DESCRIPTION
Table 65
Advanced Setup > QoS > Rule&Action Summary
LABEL
DESCRIPTION
Rules
#
This is the rule’s index number.
Active
This shows whether the rule is enabled or disabled.
Physical Ports
This is the physical port associated with the rule.
Destination MAC
and IP/Mask Port
Ranges
This is the port range for destination MAC address and IP address.
Source MAC and IP/
Mask Port Ranges
This is the port range for source MAC address and IP address.
Protocol ID
This is the protocol ID associated with the rule.
VLAN ID
This is the VLAN ID associated with the rule.