ZyXEL Communications Corporation AMG1302 Manuel D’Utilisation
Chapter 8 Wireless LAN
AMG1302-T10A User’s Guide
99
8.2 The AP Screen
Use this screen to configure the wireless settings of your Device. Click Network > Wireless LAN
to open the AP screen.
Figure 46
Network > Wireless LAN > AP
The following table describes the labels in this screen.
Table 28
Network > Wireless LAN > AP
LABEL
DESCRIPTION
Wireless Setup
Enable Wireless
Enable Wireless
LAN
Click the check box to activate wireless LAN.
Channel
Selection
Select the country in which you are using the device. Set the operating frequency/channel.
Select Auto to automatically scan for a channel.
Common Setup
Network Name
Network Name
(SSID)
The SSID (Service Set IDentity) identifies the service set with which a wireless device is
associated. Wireless devices associating to the access point (AP) must have the same
SSID. Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless
LAN.
Note: If you are configuring the Device from a computer connected to the wireless LAN and
you change the Device’s SSID or WEP settings, you will lose your wireless
connection when you press Apply to confirm. You must then change the wireless
settings of your computer to match the Device’s new settings.
connection when you press Apply to confirm. You must then change the wireless
settings of your computer to match the Device’s new settings.
Hide SSID
Select this check box to hide the SSID in the outgoing beacon frame so a station cannot
obtain the SSID through scanning using a site survey tool.
Security Mode
See the following sections for more details about this field.
MAC Filter
This shows whether the wireless devices with the MAC addresses listed are allowed or
denied to access the Device using this SSID.
Edit
Click this to go to the MAC Filter screen to configure MAC filter settings. See
for more details.
QoS
Select this check box to activate Quality of Service (QoS).
Apply
Click this to save your changes.