ZyXEL Communications Corporation EMG2926Q10A Manuel D’Utilisation

Chapter 7 Access Point Mode

EMG2926-Q10A User’s Guide

Use the menu in the navigation panel to configure EMG2926-Q10A features in Access Point Mode.

Menu: Access Point Mode 

Refer to 

 for descriptions of the labels shown in the navigation panel.

Use this section to configure your LAN settings while in Access Point Mode. 

Click Network > LAN to see the screen below.

Note: If you change the IP address of the EMG2926-Q10A in the screen below, you will 

need to log into the EMG2926-Q10A again using the new IP address.

- CPU Usage

This displays what percentage of the EMG2926-Q10A’s processing ability is currently used. 
When this percentage is close to 100%, the EMG2926-Q10A is running at full load, and the 
throughput is not going to improve anymore. If you want some applications to have more 
throughput, you should turn off other applications (for example, using bandwidth 
management.)

- Memory Usage

This shows what percentage of the heap memory the EMG2926-Q10A is using. 

Interface Status

Interface

This displays the EMG2926-Q10A port types. The port types are: LAN and WLAN.

Status

For the LAN ports, this field displays Down (line is down) or Up (line is up or connected).

For the 2.4GHz/5GHz WLAN, it displays Up when the 2.4GHz/5GHz WLAN is enabled or 
Down when the 2.4G/5G WLAN is disabled.

Rate

For the LAN ports, this displays the port speed and duplex setting or N/A when the line is 
disconnected.

For the 2.4GHz/5GHz WLAN, it displays the maximum transmission rate when the 2.4GHz/
5GHz WLAN is enabled and N/A when the WLAN is disabled.

Status Screen: Access Point Mode (continued)