ZyXEL Communications Corporation EMG6765-Q10A Manuel D’Utilisation

 Chapter 13 NAT

EMG6765-Q10A User’s Guide

To change your EMG6765-Q10A’s trigger port settings, click Network > NAT > Port Trigger. The screen 
appears as shown.

Note: Only one LAN computer can use a trigger port (range) at a time.

Figure 63   Network > NAT > Port Trigger 

The following table describes the labels in this screen.

Table 48   Network > NAT > Port Trigger

#

This is the rule index number (read-only).

Name

Type a unique name (up to 15 characters) for identification purposes. All characters are 
permitted - including spaces.

Incoming

Incoming is a port (or a range of ports) that a server on the WAN uses when it sends out a 
particular service. The EMG6765-Q10A forwards the traffic with this port (or range of ports) to 
the client computer on the LAN that requested the service. 

Port

Type a port number or the starting port number in a range of port numbers.

End Port

Type a port number or the ending port number in a range of port numbers.

Trigger

The trigger port is a port (or a range of ports) that causes (or triggers) the EMG6765-Q10A to 
record the IP address of the LAN computer that sent the traffic to a server on the WAN.

Port

Type a port number or the starting port number in a range of port numbers.

End Port

Type a port number or the ending port number in a range of port numbers.

Timer (Mins)

Enter the interval (in minutes) a trigger port records an IP address of the client requesting the 
service.