ZyXEL Communications Corporation EMG6765-Q10A Manuel D’Utilisation

Chapter 15 Static Route

EMG6765-Q10A User’s Guide

Figure 68   Network > Static Route

The following table describes the labels in this screen. 

Click the Add Static Route button or a rule’s Edit icon in the Static Route screen. Use this screen to 
configure the required information for a static route. 

Figure 69   Network > Static Route: Add/Edit 

Table 50   Network > Static Route

Add Static Route

Click this to create a new rule.

Static Route Rules

#

This is the number of an individual static route.

Status

This field indicates whether the rule is active (yellow bulb) or not (gray bulb).

Name

This field displays a name to identify this rule.

Destination

This parameter specifies the IP network address of the final destination. Routing is always 
based on network number. 

Gateway

This is the IP address of the gateway. The gateway is a router or switch on the same network 
segment as the device's LAN or WAN port. The gateway helps forward packets to their 
destinations.

Subnet Mask

This parameter specifies the IP network subnet mask of the final destination.

Interface

This is the WAN interface through which the traffic is routed. 

Modify

Click the Edit icon to open a screen where you can modify an existing rule. 

Click the Delete icon to remove a rule from the EMG6765-Q10A.

Apply

Click Apply to save your changes back to the EMG6765-Q10A.

Cancel

Click Cancel to begin configuring this screen afresh.