ZyXEL Communications Corporation EMG6765-Q10A Manuel D’Utilisation
EMG6765-Q10A User’s Guide
30
5.3.1 Setting your EMG6765-Q10A to AP Mode
1
Log into the Web Configurator if you haven’t already. See the Quick start Guide for instructions on how
to do this.
to do this.
2
To use your EMG6765-Q10A as an access point, go to Maintenance > Sys OP Mode and select Access
Point Mode.
Figure 11 Changing to Access Point mode
Point Mode.
Figure 11 Changing to Access Point mode
Note: You have to log in to the Web Configurator again when you change modes. As soon as
you do, your EMG6765-Q10A is already in Access Point mode.
3
When you select Access Point Mode, the following pop-up message window appears.
Figure 12 Pop up for Access Point mode
Figure 12 Pop up for Access Point mode
Click OK. Then click Apply. The Web Configurator refreshes once the change to Access Point mode is
successful.
successful.
5.3.2 Accessing the Web Configurator in Access Point Mode
Log in to the Web Configurator in Access Point mode, do the following:
1
Connect your computer to the LAN port of the EMG6765-Q10A.
2
The default IP address of the EMG6765-Q10A is “192.168.1.2”. In this case, your computer must have an
IP address in the range between “192.168.1.3” and “192.168.1.254”.
IP address in the range between “192.168.1.3” and “192.168.1.254”.
3
Click Start > Run on your computer in Windows. Type “cmd” in the dialog box. Enter “ipconfig” to show
your computer’s IP address. If your computer’s IP address is not in the correct range then see
your computer’s IP address. If your computer’s IP address is not in the correct range then see
Appendix
B on page 200
for information on changing your computer’s IP address.
4
After you’ve set your computer’s IP address, open a web browser such as Internet Explorer and type
“192.168.1.2” as the web address in your web browser.
“192.168.1.2” as the web address in your web browser.