ZyXEL Communications Corporation EMG6765-Q10A Manuel D’Utilisation

 Chapter 9 Wireless LAN

EMG6765-Q10A User’s Guide

Use this screen when you want to add a wireless station using WPS. To open this screen, click Network > 
Wireless LAN 2.4G/5G > WPS Station.

Note: After you click Push Button on this screen, you have to press a similar button in the 

wireless station utility within 2 minutes. To add the second wireless station, you have to 

press these buttons on both device and the wireless station again after the first 2 

minutes.

Figure 44   Network > Wireless LAN 2.4G/5G > WPS Station

The following table describes the labels in this screen.

Use this screen to set the times your wireless LAN is turned on and off. Wireless LAN scheduling is disabled 
by default. The wireless LAN can be scheduled to turn on or off on certain days and at certain times. To 
open this screen, click Network > Wireless LAN 2.4G/5G > Scheduling tab.

Apply

Click Apply to save your changes back to the EMG6765-Q10A.

Cancel

Click Cancel to reload the previous configuration for this screen.

Table 27   Network > Wireless LAN 2.4G/5G > WPS (continued)

Table 28   Network > Wireless LAN 2.4G/5G > WPS Station

Push Button

Use this button when you use the PBC (Push Button Configuration) method to configure 
wireless station’s wireless settings. 

Click this to start WPS-aware wireless station scanning and the wireless security information 
synchronization. 

Or input station’s PIN 
number

Use this button when you use the PIN Configuration method to configure wireless station’s 
wireless settings. 

Type the same PIN number generated in the wireless station’s utility. Then click Start to 
associate to each other and perform the wireless security information synchronization.