ZyXEL Communications Corporation G-220F Manuel D’Utilisation
ZyXEL G-220F User’s Guide
Chapter 4 Access Point Mode Configuration
50
C
H A P T E R
4
Access Point Mode
Configuration
This chapter shows you how to configure your ZyXEL G-220F in access point mode.
4.1 Access Point Mode Introduction
To set your ZyXEL G-220F as an Access Point (AP), refer to
.
In access point mode, your ZyXEL G-220F functions as an access point. This allows you to set
up your wireless networks without using a dedicated AP device. Up to 16 wireless stations can
associate to the ZyXEL G-220F.
up your wireless networks without using a dedicated AP device. Up to 16 wireless stations can
associate to the ZyXEL G-220F.
4.1.1 Additional Setup Requirements
To bridge your wired and wireless network using the ZyXEL G-220F, the following
requirements must be met:
requirements must be met:
1 The ZyXEL G-220F must be installed on a computer connected to the wired network.
for an example) or
bridge the two interfaces (wireless and wired) on the computer.
3 Set the wireless station’s IP address to be in the same subnet as the computer in which the
ZyXEL G-220F is installed. Refer to
.
4.2 The Link Info Screen
Select the AP Mode radio button and wait for about five seconds to display the screen as
shown.
shown.