ZyXEL Communications Corporation G220V2 Manuel D’Utilisation

ZyXEL G-220 v2 User’s Guide

34

Chapter 2 Wireless LAN Network

See the user’s guide for more information.     

1 If you enabled OTIST in the wireless client, you see this screen each time you start the 

utility. Click Yes for it to search for an OTIST-enabled AP.

2 If an OTIST-enabled wireless client loses its wireless connection for more than ten 

seconds, it will search for an OTIST-enabled AP for up to one minute. (If you manually 
have the wireless client search for an OTIST-enabled AP, there is no timeout; click 
Cancel in the OTIST progress screen to stop the search.)

3 When the wireless client finds an OTIST-enabled AP, you must still click Start in the AP 

OTIST web configurator screen or hold in the Reset button (for one or two seconds) for 
the AP to transfer settings.

4 If you change the SSID or the keys on the AP after using OTIST, you need to run OTIST 

again or enter them manually in the wireless client(s).

5 If you configure OTIST to generate a WPA-PSK key, this key changes each time you run 

OTIST. Therefore, if a new wireless client joins your wireless network, you need to run 
OTIST on the AP and ALL the wireless clients again.

1 In the AP, a web configurator screen pops 

up showing you the security settings to 
transfer. After reviewing the settings, click 
OK.

2 This screen appears while OTIST settings are being transferred. It closes when the 

transfer is complete. 

• In the wireless client, you see this screen if 

it can't find an OTIST-enabled AP (with the 
same Setup key). Click OK to go back to 
the ZyXEL utility main screen.

• If there is more than one OTIST-enabled AP within range, you see a screen asking you 

to select one AP to get settings from.