ZyXEL Communications Corporation IPC2605N Manuel D’Utilisation
9.3 Resetting to Factory Defaults
If you’ve forgotten your password, or your camera’s been acting generally strange, you
can follow the steps below to reset the camera to its default settings. To reset the camera:
can follow the steps below to reset the camera to its default settings. To reset the camera:
1) Press and hold the reset button (located on the camera’s rear panel) for
approximately 10 seconds. When successful, you should see the status indicator
light turn off.
light turn off.
2) After approximately 5 more seconds, the status indicator light should turn on
again. This indicates that the camera has been successfully reset to factory
defaults.
defaults.
3) Reconfigure your camera using the eaZy Wizard.
Once the camera is reset, it will take approximately 1 minute to reboot. Wait for it to
finish, then load the eaZy Wizard to scan for the camera.