ZyXEL Communications Corporation NBG2105 Manuel D’Utilisation
Chapter 1 Introduction
NBG2105 User’s Guide
17
1.8.1 LEDs
Figure 2
Top Panel LEDs
The following table describes the LEDs.
Operation Mode
Switch
Switch
Slide this to Router to put the NBG2105 into router or AP mode.
Slide this to Client to put the NBG2105 into WLAN client mode.
Slide this to WISP+UR to put the NBG2105 into WISP+UR mode.
Clone MAC
Push this for 2 to 5 seconds to clone the first client's MAC address.
Push this for more than 5 seconds to reset the NBG2105’s MAC address to the factory
default.
default.
Note: This only works in Router mode.
Micro USB
Connect this to a power supply or computer. Connect to a computer to use as an Ethernet
interface.
interface.
Reset
(on the underside
of the NBG2105)
(on the underside
of the NBG2105)
Push this for more than 5 seconds to reset all NBG2105 settings to factory defaults.
Table 1
General Hardware Features (continued)
FEATURE
DESCRIPTION
Table 2
Top Panel LEDs
LED
COLOR
STATUS
DESCRIPTION
Ethernet
Blue
On
The NBG2105’s Ethernet connection is ready.
Blinking
The NBG2105 is sending/receiving data through the Ethernet
port.
port.
Off
The Ethernet connection is not ready, or has failed.
Power
WLAN
WPS/
Ethernet
MAC Clone