ZyXEL Communications Corporation NBG2105 Manuel D’Utilisation
Chapter 10 WAN
NBG2105 User’s Guide
76
Figure 44
Network > WAN: DHCP Client
The following table describes the labels in this screen.
10.4.3 PPPoE
The NBG2105 supports PPPoE (Point-to-Point Protocol over Ethernet). PPPoE is an IETF standard
(RFC 2516) specifying how a personal computer (PC) interacts with a broadband modem (DSL,
cable, wireless, etc.) connection. The PPPoE option is for a dial-up connection using PPPoE.
(RFC 2516) specifying how a personal computer (PC) interacts with a broadband modem (DSL,
cable, wireless, etc.) connection. The PPPoE option is for a dial-up connection using PPPoE.
For the service provider, PPPoE offers an access and authentication method that works with existing
access control systems (for example Radius).
access control systems (for example Radius).
One of the benefits of PPPoE is the ability to let you access one of multiple network services, a
function known as dynamic service selection. This enables the service provider to easily create and
offer new IP services for individuals.
function known as dynamic service selection. This enables the service provider to easily create and
offer new IP services for individuals.
Table 34
Network > WAN: DHCP Client
LABEL
DESCRIPTION
WAN Access Type
Select DHCP Client to make the NBG2105 get its IP configuration from a DHCP server.
MTU Size
Enter the MTU (Maximum Transmission Unit) size for each packet. If a larger packet
arrives, the NBG2105 divides it into smaller fragments.
arrives, the NBG2105 divides it into smaller fragments.
Attain DNS
Automatically
Automatically
Select this to configure the NBG2105 to get addresses of DNS servers via DHCP.
Set DNS Manually
Select this to configure the NBG2105 to use DNS server addresses manually.
DNS 1
Enter the IP address of the primary DNS server.
DNS 2
(Optional)
Enter the IP address of the secondary DNS server.
Clone MAC Address
Enter the MAC address of the WAN interface.
This field is available only when the NBG2105 is in router mode.
Clear Mac Clone
Click this to reset the MAC address of the WAN interface to factory defaults.
This field is available only when the NBG2105 is in router mode.
Apply Changes
Click this to save changes back to the NBG2105.
Reset
Click this to begin configuring this screen afresh.