ZyXEL Communications Corporation NBG419N Manuel D’Utilisation
Chapter 22 Remote Management
NBG-419N Users Guide
184
22.3.1 Remote Management and NAT
When NAT is enabled:
Use the NBG-419Ns WAN IP address when configuring from the WAN.
Use the NBG-419Ns LAN IP address when configuring from the LAN.
Use the NBG-419Ns LAN IP address when configuring from the LAN.
22.3.2 System Timeout
There is a default system management idle timeout of five minutes (three
hundred seconds). The NBG-419N automatically logs you out if the management
session remains idle for longer than this timeout period. The management session
does not time out when a statistics screen is polling. You can change the timeout
period in the System screen
hundred seconds). The NBG-419N automatically logs you out if the management
session remains idle for longer than this timeout period. The management session
does not time out when a statistics screen is polling. You can change the timeout
period in the System screen
22.4 WWW Screen
To change your NBG-419Ns remote management settings, click Management >
Remote Management > WWW.
Remote Management > WWW.
Figure 111 Management > Remote Management > WWW
The following table describes the labels in this screen
Table 71
Management > Remote Management > WWW
LABEL
DESCRIPTION
Server Port
You may change the server port number for a service if needed,
however you must use the same port number in order to use that
service for remote management.
however you must use the same port number in order to use that
service for remote management.
Server Access
Select the interface(s) through which a computer may access the NBG-
419N using this service.
419N using this service.
Secured Client
IP Address
IP Address
Select All to allow all computes to access the NBG-419N.
Otherwise, check Selected and specify the IP address of the computer
that can access the NBG-419N.
that can access the NBG-419N.
om
pan
y
on
fiden
tial