ZyXEL Communications Corporation NBG419N Manuel D’Utilisation

Chapter 6 Easy Mode

NBG-419N Users Guide

6.6.6 Wireless Security

Use this screen to configure security for your the Wireless LAN. You can enter the
SSID and select the wireless security mode in the following screen.

Note: You can enable the Wireless function of your NBG-419N by first turning on the

switch in the back panel.

Figure 36 Wireless Security

The following table describes the general wireless LAN labels in this screen.

Table 21 Wireless Security

LABEL

DESCRIPTION

Wireless
Network
Name (SSID)

(Service Set IDentity) The SSID identifies the Service Set with which a
wireless station is associated. Wireless stations associating to the access
point (AP) must have the same SSID. Enter a descriptive name (up to 32
keyboard characters) for the wireless LAN.

The default SSID is NBG-419N.

Security
mode

Select WPA-PSK or WPA2-PSK to add security on this wireless
network. The wireless clients which want to associate to this network
must have same wireless security settings as this device. After you select
to use a security, additional options appears in this screen.

Select No Security to allow any client to connect to this network without
authentication.

Wireless
password

This field appears when you choose wither WPA-PSK or WPA2-PSK as
the security mode.

Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.

Verify
password

Type the password again to confirm.

Apply

Click Apply to save your changes back to the NBG-419N.

Cancel

Click Cancel to close this screen.

WPS

Click this to configure the WPS screen.

You can transfer the wireless settings configured here (Wireless
Security screen) to another wireless device that supports WPS.

pan

fiden

tial