ZyXEL Communications Corporation NBG6616 Manuel D’Utilisation

 Chapter 1 Introduction

NBG6616 User’s Guide

You may need screw anchors if mounting on a concrete or brick wall.

Select a position free of obstructions on a wall strong enough to hold the weight of the device. 

Mark two holes on the wall at the appropriate distance apart for the screws.

If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the 
full depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way 
in - leave a small gap of about 0.5 cm.

If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the 
screws all the way in - leave a gap of about 0.5 cm.

Make sure the screws are fastened well enough to hold the weight of the NBG6616 with the 
connection cables. 

WAN

Green

On

The NBG6616’s WAN connection is ready. 

Blinking

The NBG6616 is sending/receiving data through the WAN.

Off

The WAN connection is not ready, or has failed.

LAN 1-4

Green

On

The NBG6616’s LAN connection is ready. 

Blinking

The NBG6616 is sending/receiving data through the LAN.

Off

The LAN connection is not ready, or has failed.

2.4G/5G WLAN

Green

On

The NBG6616 is ready and the 2.4GHz/5GHz wireless LAN is on, 
but is not sending/receiving data through the wireless LAN. 

Blinking

The NBG6616 is sending/receiving data through the wireless 
LAN.

Off

The wireless LAN is not ready or has failed.

WPS

Green

On

WPS is enabled.

Blinking

The NBG6616 is negotiating a WPS connection with a wireless 
client.

Off

WPS is disabled.

USB 1/2

Green

On

The NBG6616 has a USB device installed.

Blinking

The NBG6616 is transmitting and/or receiving data from routers 
through an installed USB device.

Off

There is no USB device connected to the NBG6616.

Front panel LEDs (continued)

Wall Mounting Information

Distance between holes

13 cm

M4 Screws

Two

Screw anchors (optional)

Two