ZyXEL Communications Corporation NBG6616 Manuel D’Utilisation
Chapter 22 Remote Management
NBG6616 User’s Guide
155
22.3.1 Remote Management and NAT
When NAT is enabled:
• Use the NBG6616’s WAN IP address when configuring from the WAN.
• Use the NBG6616’s LAN IP address when configuring from the LAN.
• Use the NBG6616’s LAN IP address when configuring from the LAN.
22.3.2 System Timeout
There is a default system management idle timeout of five minutes (three hundred seconds). The
NBG6616 automatically logs you out if the management session remains idle for longer than this
timeout period. The management session does not time out when a statistics screen is polling. You
can change the timeout period in the Maintenance > General screen
NBG6616 automatically logs you out if the management session remains idle for longer than this
timeout period. The management session does not time out when a statistics screen is polling. You
can change the timeout period in the Maintenance > General screen
22.4 WWW Screen
To change your NBG6616’s remote management settings, click Management > Remote MGMT >
WWW.
WWW.
Figure 100
Management > Remote Management > WWW
The following table describes the labels in this screen.
Table 69
Management > Remote Management > WWW
LABEL
DESCRIPTION
Port
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
use the same port number in order to use that service for remote management.
Access Status
Select the interface(s) through which a computer may access the NBG6616 using
this service.
this service.
Secured Client IP
Address
Address
Select All to allow all computes to access the NBG6616.
Otherwise, check Selected and specify the IP address of the computer that can
access the NBG6616.
access the NBG6616.
Apply
Click Apply to save your customized settings.
Cancel
Click Cancel to begin configuring this screen afresh.