ZyXEL Communications Corporation NWD670 Manuel D’Utilisation

ZyXEL Communications Corp.

Proprietary & Confidential Information

Specifications are subject to change without notice

iii

1. This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. In order to avoid the possibility of exceeding the FCC
radio frequency exposure limits, human proximity to the antenna (installed to end
product) shall not be less than 20 cm (8 inches) during normal operation.

This Transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter

As long as the 2 conditions above are met, further transmitter testing will

not be

required. However, the OEM integrator is still responsible for testing their
end-product for any additional compliance requirements required with this
module installed (for example, digital device emission, PC peripheral
requirements, etc.).

Additional Information that Must be Provided to OEM Integrators:

The end user should NOT be provided any instructions on how to remove or install the device.

IMPORTANT NOTE.

1) In the event that these conditions cannot be met (for example certain laptop configurations or

co-location with another transmitter), then the FCC authorization is no longer considered valid and

the FCC ID cannot be used on the final product. In these circumstances, the OEM integrator will be

responsible for re-evaluating the end product (including the transmitter) and obtaining a separate

FCC authorization.

2) To comply with FCC RF exposure compliance requirements, the antenna used for this

transmitter must be installed to provide a separation distance of at least 20 cm from all persons and

must not be co-located or operating in conjunction with any other antenna or transmitter."

End Product Labeling

This transmitter module is authorized only for use in devices where the antenna may be installed

such that 20 cm may be maintained between the antenna and users (for example access points,

routers, wireless ASDL modems, and similar equipment). The final end product must be labeled in

a visible area with the following: "Contains TX FCC ID:

I88NWD670