ZyXEL Communications Corporation OX253P Manuel D’Utilisation
Chapter 6 The LAN Configuration Screens
OX253P User’s Guide
59
6.5 Other Settings
Click ADVANCED > LAN Configuration > Other Settings to set the RIP and
Multicast options.
Multicast options.
Figure 16 ADVANCED > LAN Configuration > Other Settings
IP Subnet Mask Enter the subnet mask that defines the range of destination IP
addresses that this static route affects. If this static route affects only
one IP address, enter 255.255.255.255.
Gateway IP
Address
Address
Enter the IP address of the gateway to which the OX253P should send
packets for the specified Destination. The gateway is a router or a
switch on the same network segment as the device's LAN or WAN port.
The gateway helps forward packets to their destinations.
packets for the specified Destination. The gateway is a router or a
switch on the same network segment as the device's LAN or WAN port.
The gateway helps forward packets to their destinations.
Metric
Usually, you should keep the default value. This field is related to RIP.
The metric represents the "cost of transmission". A router determines
the best route for transmission by choosing a path with the lowest
"cost". The smaller the metric, the lower the "cost". RIP uses hop count
as the measurement of cost, where 1 is for a directly-connected
network. The metric must be 1-15; if you use a value higher than 15,
the routers assume the link is down.
the best route for transmission by choosing a path with the lowest
"cost". The smaller the metric, the lower the "cost". RIP uses hop count
as the measurement of cost, where 1 is for a directly-connected
network. The metric must be 1-15; if you use a value higher than 15,
the routers assume the link is down.
Apply
Click to save your changes.
Cancel
Click to return to the previous screen without saving your changes.
Table 16 Advanced> LAN Configuration > IP Static Route Setup > Edit (continued)
LABEL
DESCRIPTION