ZyXEL Communications Corporation P8802T Manuel D’Utilisation
Chapter 9 Routing
Basic Home Station VDSL2 P8802T User’s Guide
141
The following table describes the labels in this screen.
9.3.1 Add Static Route
Use this screen to add a static route. Click Add in the Static Route screen to display the following
screen.
screen.
Figure 53
Static Route: Add
The following table describes the labels in this screen.
Table 46
Static Route
LABEL
DESCRIPTION
IP Version
This displays whether the entry uses IPv4 or IPv6.
DstIP/
PrefixLength
PrefixLength
This specifies the IP network address and prefix length of the final destination. Routing is
always based on network number.
always based on network number.
Gateway
This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
Interface
This is the interface this static route uses to forward traffic for the listed destination
address.
address.
Metric
The metric represents the "cost of transmission". A router determines the best route for
transmission by choosing a path with the lowest "cost". The smaller the number, the lower
the "cost".
transmission by choosing a path with the lowest "cost". The smaller the number, the lower
the "cost".
Remove
Select entries and click the Remove button to delete them.
Add
Click this to configure a new static route.
Table 47
Static Route: Add (Sheet 1 of 2)
LABEL
DESCRIPTION
IP Version
Select whether your IP type is IPv4 or IPv6.
Destination IP
address/prefix
length
address/prefix
length
Enter the IPv4 or IPv6 address and network length of the final destination.
Interface
Select the interface through which this static route sends traffic.