ZyXEL Communications Corporation P8802T Manuel D’Utilisation

Chapter 1 Introducing the VDSL Router

Basic Home Station VDSL2 P8802T User’s Guide

The USB port (at the right side of the device when you 
face to the front panel) allows you to wirelessly 
connect to a 3G netowk to get Internet access by 
attaching a 3G dongle. You must leave the VDSL 
Router DSL or Ethernet WAN port unconnected and 
attached a 3G dongle to use 3G as your WAN. You can 
also heve the VDSL Router use the 3G WAN 
connection as a backup. That means the VDSL Router 
switches to the 3G wireless WAN connection after the 
wired DSL or Ethernet WAN connection fails. The 
VDSL Router automatically changes back to use the 
wired DSL or Ethernet WAN connection when it is 
available.

Figure 2   Internet Access Application: 3G WAN 

If you forget your password or cannot access the web configurator, you will need to use the RESET 
button at the back of the device to reload the factory-default configuration file. This deletes all your  
and the password will be reset to “1234”. 

Make sure the Power LED is green and on (not blinking and not red or flashing red).

To set the device back to the factory default settings, press the RESET button for ten seconds or 
until the Power LED begins to blink and then release it. When the Power LED begins to blink, the 
defaults have been restored and the device restarts.

Note: The default username and password are on the label on the bottom of the Device.