ZyXEL Communications Corporation PK5001Z Manuel D’Utilisation

PK5001Z Quick Start Guide

Hardware Connections

1 DSL: Use the gray telephone wire to connect your PK5001Z

’s DSL port

to a telephone jack (or to the modem port on a splitter if you are using

one).

2 ETHERNET: Use the yellow Ethernet cable to connect a computer to an

ETHERNET port for initial configuration and/or Internet access.

3 POWER: Use the included power adaptor to connect an appropriate

power source to the POWER socket. Make sure the power source is on.

4 Push in the POWER button.

5 Look at the lights on the front panel.

• The POWER light blinks while your PK5001Z starts up and stays on

once it is ready.

• Each ETHERNET light stays on if the corresponding ETHERNET port is

properly connected and blinks when there is traffic.

• The DSL light is on when the PK5001Z has a DSL connection.

• The INTERNET light is on when you are able to access the Internet and

blinks when the PK5001Z

Is sending or receiving data. Wait a couple of minutes while your device

checks the connection.

If any of these lights are not on, check your connections and inspect

your cables for dam age. If the lights are still off, contact your local