ZyXEL Communications Corporation PRESTIGE310S Manuel D’Utilisation
Prestige 310 Broadband Sharing Gateway
Hardware Installation & Initial Setup
2-11
You only need to configure this menu if your WAN connection is a cable modem.
Figure 2-9
Menu 2 – WAN Setup
The MAC address field allows users to configure the WAN port's MAC Address by either using the factory
default or cloning the MAC address from a workstation on your LAN. Once it is successfully configured, the
address will be copied to the rom file (ZyNOS configuration file). It will not change unless you change the
setting in Menu 2 or upload a different rom file.
The following table contains instructions on how to configure your WAN setup.
default or cloning the MAC address from a workstation on your LAN. Once it is successfully configured, the
address will be copied to the rom file (ZyNOS configuration file). It will not change unless you change the
setting in Menu 2 or upload a different rom file.
The following table contains instructions on how to configure your WAN setup.
Table 2-7
WAN Setup Menu Fields
Field
Description
Examples
MAC Address
Assigned By
Press the [SPACEBAR] to choose either of the two methods of
assigning a MAC Address. Choose Factory Default to select the
factory assigned default MAC Address. Choose IP Address attached
on LAN to use the MAC Address of that workstation whose IP you
give in the following field.
assigning a MAC Address. Choose Factory Default to select the
factory assigned default MAC Address. Choose IP Address attached
on LAN to use the MAC Address of that workstation whose IP you
give in the following field.
Factory Default
IP Address
This field is applicable only if you choose IP Address attached on LAN
method. Enter the IP address of the workstation on the LAN whose
MAC you are cloning.
method. Enter the IP address of the workstation on the LAN whose
MAC you are cloning.
Note: Your Prestige WAN Port is always set at half-duplex mode as most cable modems
only support half-duplex mode. If your cable modem supports full-duplex mode, then
you will be able to manually set it at half-duplex mode.
If the Prestige was set at half-duplex and the cable modem was set at full-duplex then
the WAN port would not function properly.
2.9 LAN
Setup
This section describes how to configure the LAN using Menu 3 – LAN Setup (10/100Mbps Ethernet).
From the Main Menu, enter 3 to open Menu 3.
From the Main Menu, enter 3 to open Menu 3.
Menu 2 - WAN Setup
MAC Address:
Assigned By=IP address attached on LAN
IP Address= 192.168.1.12
Assigned By=IP address attached on LAN
IP Address= 192.168.1.12
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle