ZyXEL Communications Corporation PRESTIGE310S Manuel D’Utilisation
Prestige 310 Broadband Sharing Gateway
5-4
Remote Node Setup
Field
Description
Examples
My IP Addr(ess)
Enter the IP address of the WAN Ethernet port.
10.0.0.140
(Default)
Server IP
Addr(ess)
Addr(ess)
Enter the IP address of the ANT modem.
10.0.0.138
(Default)
Connection
ID/Name
ID/Name
Enter the connection ID or connection name in the
ANT. It must follow the “c:id” and “n:name” format.
ANT. It must follow the “c:id” and “n:name” format.
This field is optional and depends on the requirements
of your xDSL Modem.
of your xDSL Modem.
N:My ISP
Schedules
You can apply up to four schedule sets here. For more
details please refer to the chapter Call Schedule
Setup.
details please refer to the chapter Call Schedule
Setup.
Nailed-Up
Connection
Connection
This field specifies if you want to make the connection
to this remote node a nailed-up connection. For more
details please refer to the section on Nailed-Up
Connection.
to this remote node a nailed-up connection. For more
details please refer to the section on Nailed-Up
Connection.
Nailed-Up Connection
A nailed-up connection is a dial-up line where the connection is always up regardless of traffic demand. The
Prestige does two things when you specify a nailed-up connection. The first is that idle timeout is disabled.
The second is that the Prestige will try to bring up the connection at power-on and whenever the connection
is down. A nailed-up connection can be very expensive for obvious reasons.
Prestige does two things when you specify a nailed-up connection. The first is that idle timeout is disabled.
The second is that the Prestige will try to bring up the connection at power-on and whenever the connection
is down. A nailed-up connection can be very expensive for obvious reasons.
Do not specify a nailed-up connection unless your telephone company offers flat-rate
service or you need a constant connection and the cost is of no concern.
5.1.3 PPPoE
Encapsulation
The Prestige supports PPPoE (Point-to-Point Protocol over Ethernet). You can use PPPoE encapsulation only
when you’re using the Prestige with an xDSL modem as the WAN device. If you change the Encapsulation
to PPPoE, then you will see the next screen. Please see section 3.3.2 for more information on PPPoE.
when you’re using the Prestige with an xDSL modem as the WAN device. If you change the Encapsulation
to PPPoE, then you will see the next screen. Please see section 3.3.2 for more information on PPPoE.