ZyXEL Communications Corporation VMG1312B10A Manuel D’Utilisation

 Chapter 1 Introducing the Device

VMG1312-B10A User’s Guide

If you forget your password or cannot access the web configurator, you will need to use the RESET 
button at the back of the device to reload the factory-default configuration file. This means that you 
will lose all configurations that you had previously and the password will be reset to “1234”. 

Make sure the POWER LED is on (not blinking).

To set the device back to the factory default settings, press the RESET button for ten seconds or 
until the POWER LED begins to blink and then release it. When the POWER LED begins to blink, 
the defaults have been restored and the device restarts.

The Device is a wireless Access Point (AP) for wireless clients, such as notebook computers or PDAs 
and iPads. It allows them to connect to the Internet without having to rely on inconvenient Ethernet 
cables.

INTERNET

Green

On

The Device has an IP connection but no traffic.

Your device has a WAN IP address (either static or assigned by a DHCP 
server), PPP negotiation was successfully completed (if used) and the 
DSL connection is up.

Blinking

The Device is sending or receiving IP traffic.

Off

There is no Internet connection or the gateway is in bridged mode.

Red

On

The Device attempted to make an IP connection but failed. Possible 
causes are no response from a DHCP server, no PPPoE response, PPPoE 
authentication failed.

USB

Green

On

The Device recognizes a USB connection.

Blinking

The Device is sending/receiving data to /from the USB device connected 
to it.

Off

The Device does not detect a USB connection.

LED Descriptions (continued)