ZyXEL Communications Corporation VMG1312B10A Manuel D’Utilisation
Chapter 35 Diagnostic
VMG1312-B10A User’s Guide
288
35.4 802.1ag
Click Maintenance > Diagnostic > 8.2.1ag to open the following screen. Use this screen to
perform CFM actions.
perform CFM actions.
Figure 145
Maintenance > Diagnostic > 802.1ag
The following table describes the fields in this screen.
Table 109
Maintenance > Diagnostic > 802.1ag
LABEL
DESCRIPTION
802.1ag Connectivity Fault Management
Maintenance
Domain (MD)
Level
Domain (MD)
Level
Select a level (0-7) under which you want to create an MA.
Destination
MAC Address
MAC Address
Enter the target device’s MAC address to which the Device performs a CFM loopback test.
802.1Q VLAN
ID
ID
Type a VLAN ID (0-4095) for this MA.
VDSL Traffic
Type
Type
This shows whether the VDSL traffic is activated.
Loopback
Message (LBM)
Message (LBM)
This shows how many Loop Back Messages (LBMs) are sent and if there is any inorder or
outorder Loop Back Response (LBR) received from a remote MEP.
outorder Loop Back Response (LBR) received from a remote MEP.
Linktrace
Message (LTM)
Message (LTM)
This shows the destination MAC address in the Link Trace Response (LTR).
Set MD Level
Click this button to configure the MD (Maintenance Domain) level.
Send Loopback
Click this button to have the selected MEP send the LBM (Loop Back Message) to a specified
remote end point.
remote end point.
Send Linktrace
Click this button to have the selected MEP send the LTMs (Link Trace Messages) to a
specified remote end point.
specified remote end point.