ZyXEL Communications Corporation VMG1312B10A Manuel D’Utilisation

Page de 378
VMG1312-B10A User’s Guide
365
A
P P E N D I X
      G
Legal Information
Copyright
Copyright © 2011 by MitraStar Communications Corporation.
The contents of this publication may not be reproduced in any part or as a whole, transcribed, 
stored in a retrieval system, translated into any language, or transmitted in any form or by any 
means, electronic, mechanical, magnetic, optical, chemical, photocopying, manual, or otherwise, 
without the prior written permission of ZyXEL Communications Corporation.
Published by MitraStar Communications Corporation. All rights reserved.
Disclaimer
MitraStar does not assume any liability arising out of the application or use of any products, or 
software described herein. Neither does it convey any license under its patent rights nor the patent 
rights of others. ZyXEL further reserves the right to make changes in any products described herein 
without notice. This publication is subject to change without notice.
Certifications 
Federal Communications Commission (FCC) Interference Statement
The device complies with Part 15 of FCC rules. Operation is subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause 
undesired operations.
This device has been tested and found to comply with the limits for a Class B digital device pursuant 
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This device generates, uses, and can radiate radio 
frequency energy, and if not installed and used in accordance with the instructions, may cause 
harmful interference to radio communications. However, there is no guarantee that interference will 
not occur in a particular installation.
If this device does cause harmful interference to radio/television reception, which can be 
determined by turning the device off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:
1
Reorient or relocate the receiving antenna.
2
Increase the separation between the equipment and the receiver.