ZyXEL Communications Corporation WAP6806 Manuel D’Utilisation

 Chapter 8 Status

WAP6806 User’s Guide

Use the menu in the navigation panel menus to configure WAP6806 features.

Menus

The following table describes the sub-menus. 

Menus

Status

This screen shows the WAP6806’s general device, system and interface 
status information.

Monitor

System Log

This screen shows the logs for categories such as system maintenance and 
system errors.

Statistics

This screen shows the packet statistics of each port and the system up 
time. You can configure the Poll Interval to refresh the screen.

WLAN Station 
Status

This screen shows the wireless stations that are currently connected to the 
WAP6806.

Note: This is for Repeater and AP mode only.

Configuration

Operation 
Mode

Operation 
Mode Setup

Use this screen to select a system operation mode.

AP Connection

Use the screen to configure the AP connection settings.

Ethernet

LAN Setup

Use this screen to configure the LAN port’s settings.

IP Alias

Use this screen to configure the WAP6806’s IP address and subnet mask.

Wireless LAN 
2.4G / 5G (for 
Repeater and 
AP mode only)

General

Use this screen to configure wireless LAN.

Advanced

This screen allows you to configure advanced wireless settings.

Security

Use this screen to select the available security modes as defined by the 
paired AP or wireless router.

WPS

Use this screen to configure WPS.

Management

MCL

Use this screen to enable or disable services.

One Connect

Use this screen to enable or disable the auto-configuration of One Connect.

Maintenance

System

General

Use this screen to change the password.

Time Setting

Use this screen to configure the WAP6806’s time based on your local time 
zone.

Firmware 
Upgrade

Use this screen to upload firmware to your WAP6806.