ZyXEL Communications Corporation WAP6906 Manuel D’Utilisation

Chapter 8 Wireless LAN

WAP6906 User’s Guide

Note: With WPS, wireless clients can only connect to the 5GHz or 2.4GHz wireless network using 

the first SSID on the WAP6906. This means you cannot connect to the SSIDs created in 

the MBSS screen via WPS.

Figure 26   Networking > Wireless Network 5G/2.4G > WPS

The following table describes the labels in this screen.

The MAC filter screen allows you to configure the WAP6906 to give exclusive access to devices (Allow) 
or exclude devices from accessing the WAP6906 (Reject). Every Ethernet device has a unique MAC 
(Media Access Control) address. The MAC address is assigned at the factory and consists of six pairs of 

Table 16   Networking > Wireless Network 5G/2.4G > WPS

WPS Setup

State

Select Configured to enable WPS and do NOT change the wireless security key after the WPS 
connection is established.

Select Unconfigured to enable WPS but change the wireless security key after the WPS 
connection is established.

Select Disabled to turn off WPS.

WPS PBC

Click the Push Button to perform wireless security information synchronization using the Push 
Button Configuration (PBC) Method.

WPS PIN

Use this field to type the same PIN number generated in the wireless station’s utility to perform 
wireless security information synchronization using the PIN Configuration Method.

Click the WPS PIN button to establish the synchronization. The PIN should be between 4 and 8 
characters.

Device PIN Enable Select this to allow the WAP6906 to create a new PIN number. Wireless clients then can use 

the generated PIN number to perform wireless security information synchronization with the 
WAP6906 via WPS.

PIN Number

This displays a PIN number last time system generated. Click Generate to generate a new PIN 
number.

Apply

Click Apply to save your changes back to the WAP6906.

Cancel

Click Cancel to get this screen information afresh.