ZyXEL Communications Corporation WAP6906 Manuel D’Utilisation

 Chapter 11 Troubleshooting

WAP6906 User’s Guide

If you reset the WAP6906, you lose all of the changes you have made. The WAP6906 re-loads its default 
settings, and the password resets to the back-label default key. You have to make all of your changes 
again.

You will lose all of your changes when you reset the WAP6906 to its factory defaults.

To reset the WAP6906,

Make sure the power LED is on.

Press the RESET button for longer than 5 seconds, the Power LED begins to blink, to set the WAP6906 back 
to its factory-default configuration.

OR

Click Maintenance > Restore and then click Reset.

If the WAP6906 restarts automatically, wait for the WAP6906 to finish restarting, and log in to the Web 
Configurator. The password is in the device label.

If the WAP6906 does not restart automatically, disconnect and reconnect the WAP6906. Then, follow the 
directions above again.

I cannot access the WAP6906 or ping any computer from the WLAN.

Make sure the WAP6906 is working and the wireless LAN is enabled on the WAP6906.

Make sure the wireless adapter on the wireless client is working properly.

Make sure the wireless adapter installed on your computer is IEEE 802.11 compatible and supports the 
same wireless standard as the WAP6906.

Make sure your computer (with a wireless adapter installed) is within the transmission range of the 
WAP6906.

Check that both the WAP6906 and your wireless station are using the same wireless and wireless security 
settings.

Make sure traffic between the WLAN and the LAN is not blocked by the MAC Address List of the 
WAP6906. See 

.