ZyXEL Communications Corporation WAP7205 Manuel D’Utilisation

Chapter 8 MoCA

WAP7205 User’s Guide

Use this screen to change the MoCA settings for your WAP7205. Click Network > MoCA.

Figure 31   Network > MoCA 

The following table describes the labels in this screen.

Table 26   Network > MoCA

Band Selection

In MoCA frequency band plans, there are bands A, B, C1, C2, C3, C4, D, E, F, G, and H. The 
extended band D in MoCA 2.0 is between 1125 MHz and 1675 MHz. Two sub-bands (D-Low and 
D-High) are defined within the extended band D.

• Sub-band D-Low (DL): 1125 to 1225 MHz edge to edge (100 MHz wide)
• Sub-band D-High (DH): 1350 to 1675 MHz edge to edge (325 MHz wide)

At the time of writing, the WAP7205 supports the sub-band D-High only. 

LOF

Last Operational Frequency (LOF) is the last RF channel center frequency which a MoCA 
device (node) will automatically turn to when it is last in the linkup state,

The center frequency of a channel is a central frequency in the middle of the upper cutoff and 
lower cutoff frequencies. 

If you clear the Auto Channel Selection check box, manually select an operating frequency 
from the drop-down list.

Network Search

Select the check box to enable auto scan for the operating frequency.

Primary Channel

Select the first operating frequency range if you clear the Auto Channel Selection check box.

The field options vary depending on the center frequency you select in the LOF field.