ZyXEL Communications Corporation WRE6505V2 Manuel D’Utilisation
Chapter 1 Introduction
WRE6505 v2 User’s Guide
11
The following table describes the LEDs.
1.4 WPS Button
The WPS button can be used to begin Wi-Fi Protected Setup (WPS), reboot the WRE6505 v2 while
keeping it’s configuration or reboot the WRE6505 v2 to factory default configuration.
keeping it’s configuration or reboot the WRE6505 v2 to factory default configuration.
Table 1 Front Panel LEDs
LED
COLOR
STATUS
DESCRIPTION
Power/WPS
Blue
On
The WRE6505 v2 is receiving power and functioning properly.
Blinking
The WRE6505 v2 is booting, resetting to factory defaults, the
WRE6505 v2 is waiting for another WPS device to connect, or
firmware upgrade is in progress.
WRE6505 v2 is waiting for another WPS device to connect, or
firmware upgrade is in progress.
Off
The WRE6505 v2 is not receiving power, or there is no WPS
connection established.
connection established.
2.4 GHz Signal
Strength
Strength
White
On
The more the LEDs are on the better the Wi-Fi signal strength.
•
Three LEDs: signifies a signal strength of 51% ~ 100%
•
Two LEDs: signifies a signal strength of 20% ~ 50%
•
One LED: signifies a signal strength under 20%
Blinking
Firmware upgrade is in progress.
Off
The 2.4 GHz wireless LAN is not enabled, there is no signal
detected or the WRE6505 v2 (repeater mode) is not connected
to a wireless router/AP, or the LEDs are turned off using the
WPS button.
detected or the WRE6505 v2 (repeater mode) is not connected
to a wireless router/AP, or the LEDs are turned off using the
WPS button.
5 GHz Signal
Strength
Strength
White
On
The more the LEDs are on the better the Wi-Fi signal strength.
•
Three LEDs: signifies a signal strength of 51% ~ 100%
•
Two LEDs: signifies a signal strength of 20% ~ 50%
•
One LED: signifies a signal strength under 20%
Blinking
Firmware upgrade is in progress.
Off
The 5 GHz wireless LAN is not enabled, there is no signal
detected or the WRE6505 v2 (repeater mode) is not connected
to a wireless router/AP, or the LEDs are turned off using the
WPS button.
detected or the WRE6505 v2 (repeater mode) is not connected
to a wireless router/AP, or the LEDs are turned off using the
WPS button.
Table 2 WPS Button Functions
ACTION
RESULT
Press thress times within
5 seconds
5 seconds
Turn off or turn on all LEDs.
AP Mode
Push twice within 5
seconds
seconds
The WRE6505 v2 begins connecting to a wireless client via WPS. See
Hold for 5 to 10 seconds
The WRE6505 v2 keeps its configuration and reboots.
Hold for more than 10
seconds
seconds
The WRE6505 v2 resets its configuration to factory defaults and reboots. See
Repeater Mode
Push twice within 5
seconds
seconds
The WRE6505 v2 begins connecting to a wireless client via WPS. See