ZyXEL Communications Corporation WRE6505V2 Manuel D’Utilisation
Chapter 9 Wireless LAN
WRE6505 v2 User’s Guide
57
The following table describes the labels in this screen.
9.6 AP Select Screen
Use this screen (available in repeater mode only) to choose an access point that you want the
WRE6505 v2 to connect to. You should know the security settings of the target AP.
WRE6505 v2 to connect to. You should know the security settings of the target AP.
To open this screen, click N et w ork > W ireless LAN 2 .4 G or W ireless LAN 5 G > AP Select .
Figure 34 Network > Wireless LAN 2.4G/5G > AP Select (Repeater Mode)
Table 18 Network > Wireless LAN 2.4G/5G > General: WPA-PSK/WPA2-PSK
LABEL
DESCRIPTION
Security Mode
Select W PA- PSK or W PA2 - PSK to enable data encryption.
WPA-PSK
Compatible
Compatible
This field appears when you choose W PA2 - PSK as the Securit y Mode.
Check this field to allow wireless devices using W PA- PSK security mode to connect to
your WRE6505 v2.
your WRE6505 v2.
Pre-Shared Key
W PA- PSK/ W PA2 - PSK uses a simple common password for authentication.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
Group Key Update
Timer
Timer
The Group Key Updat e Tim er is the rate at which the AP sends a new group key out to
all clients.
all clients.
The default is 3 6 0 0 seconds (60 minutes).
Apply
Click Apply to save your changes back to the WRE6505 v2.
Reset
Click Reset to reload the previous configuration for this screen.