ZyXEL Communications Corporation WRE6505V2 Manuel D’Utilisation
Chapter 9 Wireless LAN
WRE6505 v2 User’s Guide
61
9.8 Wireless LAN Advanced Screen
Use this screen to configure advanced wireless LAN parameters.
Click N et w ork > W ireless LAN 2 .4 G or W ireless LAN 5 G > Advanced. The screen appears as
shown.
shown.
Figure 36 Network > Wireless LAN 2.4G/5G > Advanced
The following table describes the labels in this screen.
Table 21 Network > Wireless LAN 2.4G/5G > Advanced
LABEL
DESCRIPTION
RTS/CTS
Threshold
Threshold
Data with its frame size larger than this value will perform the RTS (Request To Send)/
CTS (Clear To Send) handshake.
CTS (Clear To Send) handshake.
Enter a value between 1 and 2 3 4 7 .
Fragmentation
Threshold
Threshold
The threshold (number of bytes) for the fragmentation boundary for directed messages.
It is the maximum data fragment size that can be sent. Enter an even number between
2 5 6 and 2 3 4 6 .
It is the maximum data fragment size that can be sent. Enter an even number between
2 5 6 and 2 3 4 6 .
Enable Intra-BSS
Traffic Blocking
Traffic Blocking
A Basic Service Set (BSS) exists when all communications between wireless clients or
between a wireless client and a wired network client go through one access point (AP).
between a wireless client and a wired network client go through one access point (AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS traffic
blocking is not enabled, wireless clients can access the wired network and communicate
with each other. When Intra-BSS traffic blocking is enabled, wireless clients can still
access the wired network but cannot communicate with each other.
blocking is not enabled, wireless clients can access the wired network and communicate
with each other. When Intra-BSS traffic blocking is enabled, wireless clients can still
access the wired network but cannot communicate with each other.
Output Power
Set the output power of the WRE6505 v2 in this field. If there is a high density of APs in
an area, decrease the output power of the WRE6505 v2 to reduce interference with other
APs. Select one of the following 1 0 0 % , 5 0 % or 2 5 % . See the product specifications for
more information on your WRE6505 v2’s output power.
an area, decrease the output power of the WRE6505 v2 to reduce interference with other
APs. Select one of the following 1 0 0 % , 5 0 % or 2 5 % . See the product specifications for
more information on your WRE6505 v2’s output power.
HT (High Throughput) Physical Mode
Guard Interval
Select Aut o to increase data throughput. However, this may make data transfer more
prone to errors.
prone to errors.
Select Long to prioritize data integrity. This may be because your wireless network is
busy and congested or the WRE6505 v2 is located in an environment prone to radio
interference.
busy and congested or the WRE6505 v2 is located in an environment prone to radio
interference.
Apply
Click Apply to save your changes to the WRE6505 v2.
Reset
Click Reset to reload the previous configuration for this screen.