ZyXEL Communications Corporation WRE6606 Manuel D’Utilisation
Chapter 10 Wireless LAN
WRE6606 User’s Guide
71
The following table describes the labels in this screen.
10.9 Quality of Service (QoS) Screen
The QoS screen allows you to automatically give a service (such as VoIP and video) a priority level.
Click N et w ork > W ireless LAN 2 .4 G or W ireless LAN 5 G > QoS. The following screen appears.
Figure 49 Network > Wireless LAN 2.4G/5G > QoS
The following table describes the labels in this screen.
Table 23 Network > Wireless LAN 2.4G/5G > Advanced
LABEL
DESCRIPTION
RTS/CTS
Threshold
Threshold
Data with its frame size larger than this value will perform the RTS (Request To Send)/
CTS (Clear To Send) handshake.
CTS (Clear To Send) handshake.
Enter a value between 1 and 2 3 4 7 .
Enable Intra-BSS
Traffic Blocking
Traffic Blocking
A Basic Service Set (BSS) exists when all communications between wireless clients or
between a wireless client and a wired network client go through one access point (AP).
between a wireless client and a wired network client go through one access point (AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS traffic
blocking is not enabled, wireless clients can access the wired network and communicate
with each other. When Intra-BSS traffic blocking is enabled, wireless clients can still
access the wired network but cannot communicate with each other.
blocking is not enabled, wireless clients can access the wired network and communicate
with each other. When Intra-BSS traffic blocking is enabled, wireless clients can still
access the wired network but cannot communicate with each other.
Output Power
Set the output power of the WRE6606 in this field. If there is a high density of APs in an
area, decrease the output power of the WRE6606 to reduce interference with other APs.
Select one of the following 1 0 0 % , 5 0 % or 2 5 % . See the product specifications for
more information on your WRE6606’s output power.
area, decrease the output power of the WRE6606 to reduce interference with other APs.
Select one of the following 1 0 0 % , 5 0 % or 2 5 % . See the product specifications for
more information on your WRE6606’s output power.
HT (High Throughput) Physical Mode
Guard Interval
Select Aut o to increase data throughput. However, this may make data transfer more
prone to errors.
prone to errors.
Select Long to prioritize data integrity. This may be because your wireless network is
busy and congested or the WRE6606 is located in an environment prone to radio
interference.
busy and congested or the WRE6606 is located in an environment prone to radio
interference.
Apply
Click Apply to save your changes to the WRE6606.
Reset
Click Reset to reload the previous configuration for this screen.
Table 24 Network > Wireless LAN 2.4G/5G > QoS
LABEL
DESCRIPTION
Enable WMM QoS
Check this to have the WRE6606 automatically give a service a priority level
according to the ToS value in the IP header of packets it sends. WMM QoS (Wifi
MultiMedia Quality of Service) gives high priority to voice and video, which makes
them run more smoothly.
according to the ToS value in the IP header of packets it sends. WMM QoS (Wifi
MultiMedia Quality of Service) gives high priority to voice and video, which makes
them run more smoothly.