Digigram LXIP Manuel D’Utilisation
LX1616ESe / LX6464ESe
User manual
INFORMATION FOR THE USER
This device complies w ith part 15 of FCC rules. Operation is subject to the follow ing tw o conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply w ith the limits for a CLASS B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance w ith the
instructions contained in this data sheet, may cause harmful interference to radio and television communications. How ever, there
is no guarantee that interference w ill not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, w hich can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the follow ing measures:
●
reorient or relocate the receiving antenna
●
increase the separation betw een the equipment and the receiver
●
connect the equipment into an outlet on a circuit different from that of the receiver
●
consult the dealer or an experienced audio television technician.
Note:
Connecting this device to peripheral devices that do not comply with CLASS B requirements or using an
unshielded peripheral data cable could also result in
unshielded peripheral data cable could also result in
harmful interference to radio or television reception.
To ensure that the use of this product does not contribute to interference, it is necessary to use shielded I/O
cables.
The user is cautioned that any changes or modifications not expressly approved by Digigram could void the
user’s authority to operate this equipment.
cables.
The user is cautioned that any changes or modifications not expressly approved by Digigram could void the
user’s authority to operate this equipment.
Warning:
Electrostatic discharge (ESD) can damage several components on the board.
To avoid such damage in handling the board, take the following precautions:
Bring the device and everything that contacts it to ground potential by
providing a conductive surface and discharge paths. As a minimum, observe
these precautions:
●
Disconnect all power and signal sources.
●
Place the device on a grounded conductive work surface.
●
Ground yourself via a grounding wrist strap or by holding a
grounded object.
grounded object.
●
Ground any tool that will contact the device.
IMPORTANT NOTICE
This card has been tested and found to comply w ith the follow ing standards:
●
International: CISPR22 Class B.
●
Europe: EMC 89/336/CEE (1992) specifications.
●
United States: FCC Rules-Part 15-Class B (digital device).