Digigram MIXART8 Manuel D’Utilisation

FCC ID: IGTMIXART8

This is a copy of the page where the FCC statement is included; This statement is supplied in the package of the
product.

This device complies with part 15 of FCC rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) This device

must accept any interference received, including interference that may cause undesired

operation.

This equipment has been tested and found to comply with the limits for a CLASS B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions contained in this data sheet, may

cause harmful interference to radio and television communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

• reorient or relocate the receiving antenna

• increase the separation between the equipment and the receiver

• connect the equipment into an outlet on a circuit different from that of the receiver

• consult the dealer or an experienced audio television technician.

NOTE: Connecting this device to peripheral devices that do not comply with CLASS B

requirements or using an unshielded peripheral data cable could also result in harmful

interference to radio or television reception. The user is cautioned that any changes or

modifications not expressly approved by the party responsible for compliance could void

the user’s authority to operate this equipment. To ensure that the use of this product

does not contribute to interference, it is necessary to use shielded I/O cables.

This card has been tested and found to comply with the following standards:

• International : CISPR22 Class B

• Europe : EMC 89/336/CEE (1992) specifications (EN55022 and EN55024 standards)

• United States : FCC Rules-Part 15 - Sub Part B - Class B (digital device)

In order to guarantee compliance with the above standards in an installation,

the following must be done:

• Connectors must have a conductive shell.

• Cables must be shielded and their shield must be tightly connected to the shell of the

connectors.

• A good contact must exist between the bracket and the PC frame.

D i g i g r a m