Digigram PCXIP Manuel D’Utilisation
PCX-IP LW881e, PCX-IP LW1221e
User’s manual
INFORMATION FOR THE USER
This device complies w ith part
15
of FCC rules. Operation is subject to the follow ing tw o conditions: (
1
) This device may not cause harmful
interference, and (
2
) This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply w ith the limits for a CLASS B digital device, pursuant to Part
15
of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance w ith the instructions contained in this
data sheet, may cause harmful interference to radio and television communications. How ever, there is no guarantee that interference w ill
not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, w hich can be determined by turning the equipment off
If this equipment does cause harmful interference to radio or television reception, w hich can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the follow ing measures:
* reorient or relocate the receiving antenna
* increase the separation betw een the equipment and the receiver
* connect the equipment into an outlet on a circuit different from that of the receiver
* consult the dealer or an experienced audio television technician.
* reorient or relocate the receiving antenna
* increase the separation betw een the equipment and the receiver
* connect the equipment into an outlet on a circuit different from that of the receiver
* consult the dealer or an experienced audio television technician.
Note: Connecting this device to peripheral devices that do not comply with CLASS B requirements or using an unshielded peripheral
data cable could also result in harmful interference to radio or television reception. The user is cautioned that any changes or
modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
To ensure that the use of this product does not contribute to interference, it is necessary to use shielded I/O cables.
data cable could also result in harmful interference to radio or television reception. The user is cautioned that any changes or
modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
To ensure that the use of this product does not contribute to interference, it is necessary to use shielded I/O cables.
Warning:
Electrostatic discharge (ESD) can damage several components on the board. To avoid such damage in handling the board, take the
Electrostatic discharge (ESD) can damage several components on the board. To avoid such damage in handling the board, take the
following precautions:
Bring the device and everything that contacts it to ground potential by providing a conductive surface and discharge paths. As a minimum,
Bring the device and everything that contacts it to ground potential by providing a conductive surface and discharge paths. As a minimum,
observe these precautions:
●
Disconnect all power and signal sources.
●
Place the device on a grounded conductive work surface.
●
Ground yourself via a grounding wrist strap or by holding a grounded object.
●
Ground any tool that will contact the device.
Due to the reduced length of the PCI EXPRESS
TM
bus connector and the resulting lack of mechanical stability, we strongly advise against
transporting the PCIe
®
card(s) installed in a computer, unless its chassis or case provides a dedicated support to keep the card securely in
place in order to avoid physical damage.
IMPORTANT NOTICE
This card has been tested and found to comply with the following standards:
●
International: CISPR22 Class B
●
Europe: EMC 89/336/CEE (1992) specifications
●
United States: FCC Rules-Part 15-Class B (digital device)
In order to guarantee compliance with the above standards in an installation, the following must be done:
●
the provided cable must not be modified
●
additional cables used must have their respective shield connected to each extremity
5