Digigram VX442 Manuel D’Utilisation

FCC ID: IGTPVX442

This is a copy of the fourth page of the user’s manuals, where the FCC statement is included :

D  g r a m

This device complies with part 15 of FCC rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) This device must

accept any interference received, including interference that may cause undesired

operation.

This equipment has been tested and found to comply with the limits for a CLASS B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions contained in this data sheet, may cause harmful

interference to radio and television communications.

However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

•

 

reorient or relocate the receiving antenna

•

 

increase the separation between the equipment and the receiver

•

 

connect the equipment into an outlet on a circuit different from that of the receiver

•

 

consult the dealer or an experienced audio television technician.

NOTE: Connecting this device to peripheral devices that do not comply with CLASS B

requirements or using an unshielded peripheral data cable could also result in harmful

interference to radio or television reception. The user is cautioned that any changes or

modifications not expressly approved by the party responsible for compliance could void

the user’s authority to operate this equipment. To ensure that the use of this product does

not contribute to interference, it is necessary to use shielded I/O cables.

This card has been tested and found to comply with the following standards:

•

 

International: CISPR22 Class B.

•

 

Europe: EMC 89/336/CEE (1992) specifications.

•

 

United States: FCC Rules-Part 15-Class B (digital device).

In order to guarantee compliance with the above standards in an installation, the following

must be done:

•

 

the provided cable must not be modified.

•

 

additional cables used must have their respective shield connected to each

extremity.

•

 

The cable connected to the digital I/O must be equipped with a EMI ferrite core of

the type WURTH ELEKTRONIK ref: 742 711 1 (or equivalent), located close to the

SUB-D9 HD connector.