CNet Technology CWP854 Manuel D’Utilisation

Page de 22
Federal Communication Commission Interference Statement 
 
This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules.  These limits are designed to provide reasonable 
protection against harmful interference in a residential installation.  This equipment generates, 
uses and can radiate radio frequency energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio communications.  However, there is no 
guarantee that interference will not occur in a particular installation.    If this equipment does cause 
harmful interference to radio or television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct the interference by one of the 
following measures: 
Reorient or relocate the receiving antenna. 
Increase the separation between the equipment and receiver. 
Connect the equipment into an outlet on a circuit different from that 
to which the receiver is connected. 
Consult the dealer or an experienced radio/TV technician for help. 
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions: (1) This device may not cause harmful interference, and (2) this device must accept 
any interference received, including interference that may cause undesired operation. 
 
FCC Caution: Any changes or modifications not expressly approved by the party responsible for 
compliance could void the user's authority to operate this equipment. 
 
IMPORTANT NOTE: 
FCC Radiation Exposure Statement: 
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled 
environment. End users must follow the specific operating instructions for satisfying RF exposure 
compliance. 
 
This transmitter must not be co-located or operating in conjunction with any other antenna or 
transmitter. 
 
CNet declared that CWP-854 is limited in CH1~11 from 2400 to 2483.5 MHz by specified firmware 
controlled in USA. 
 
 
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. 
This equipment should be installed and operated with minimum distance 20cm between the radiator & 
your body.