Garmin International Inc 01113 Manuel D’Utilisation
Tracking System Owner’s Manual - Draft
G
ettInG
S
tarted
>
Installing the Batteries
The Receiver operates on two AA batteries (not
included), which are located in the back of the unit.
You can use Alkaline or NiMH batteries. See page 67
for information on setting the battery type.
included), which are located in the back of the unit.
You can use Alkaline or NiMH batteries. See page 67
for information on setting the battery type.
To install the batteries:
1. Remove the battery cover
by turning the D-Ring 1/4
turn counter-clockwise and
pulling the cover loose.
2. Insert the batteries,
observing the proper
polarity. A polarity diagram
is molded into the battery
compartment.
3. Reinstall the battery cover
by aligning the back cover
with the unit and turning the
D-Ring 1/4 turn clockwise.
Remove the batteries from the Receiver when you do
not expect to use the unit for several months. Stored
data is not lost when batteries are removed.
not expect to use the unit for several months. Stored
data is not lost when batteries are removed.
To install the Lanyard:
1. Place the loop of the Lanyard through the slot
at the at the upper left side on the back of the
unit.
2 Route the strap through the loop and pull tight.
Refer to page 9 for information on accessing the
microSD data card in the battery compartment.
USE BY
2009
USE BY
2009
Battery
Compartment
Wrist Strap
Installation
Belt Clip Button
attaches here.
(Be certain to fully
engage threads and
tighten snug)
Tracking System Owner's Manual F2 2
1/16/2007 1:51:41 PM