Garmin International Inc 03260 Manuel D’Utilisation

See the Important Safety and Product Information guide in the 

product box for product warnings and other important 

information.

À

Battery cover D-ring

Á

Micro-USB port (under battery cover)

You can use alkaline, NiMH, or lithium AAA batteries. Use NiMH 

or lithium batteries for best results.

Loosen the fabric strap that covers the battery door.

Turn the D-ring counter-clockwise, and pull up to open the 

battery door.

Insert two AAA batteries, observing polarity.

NOTE: You should verify the gasket and battery 

compartment are free of debris.

Close the battery door, and turn the D-ring clockwise.

When you do not plan to use the device for several months, 

remove the batteries. Stored data is not lost when batteries are 

removed.

Insert the strap behind the pin 

À

 at the top of the device.

Pull the strap length through to the end.

Insert the strap behind the pin 

Á

 at the bottom of the device.

If necessary, attach the strap extender to the wrist strap.

À

POWER

Hold to turn the device on and off, enter night vision mode, 
and enter watch mode.
Select to turn the backlight on and off.

Á

PAGE
GOTO

Select to scroll through the main pages in sequence.
Hold to navigate to a waypoint.

Â

ENTER
MARK

Select to open the menu for the page.
Hold to mark a waypoint.

Ã

Select to scroll through menus and pages.
Select to zoom out or zoom in on the map page.

Hold POWER.
The first time you turn on the device, you will select the 

device language.

Before you can use GPS navigation features, you must acquire 

satellite signals.
When you turn on your navigation device, the GPS receiver 

must collect satellite data and establish the current location. The 

time required to acquire satellite signals varies based on several 

factors, including how far you are from the location where you 

last used your navigation device, whether you have a clear view 

of the sky, and how long it has been since you last used your 

navigation device. The first time you turn on your navigation 

device, it may take several minutes to acquire satellite signals.

Turn on the device.

Wait while the device locates satellites.
It may take 30 to 60 seconds to acquire satellite signals.

If necessary, go to an open area, away from tall buildings and 

trees.

Select POWER.
The backlight turns on for 30 seconds.

Select POWER to turn off the backlight.

You can select PAGE to scroll through the main pages. You can 

select ENTER to open the settings menu for each page. You 

can select   or   to scroll through menus and pages and zoom 

in and out.
Map page: The map page shows your position and heading on 

the map (

).

As you travel, the position icon moves and leaves a track log 

(trail). Waypoint names and symbols appear on the map. The 

device automatically rotates the map as you move so that 

waypoints always appear above your position.

Compass page: The compass page guides you to your 

destination by displaying a compass and bearing pointer.
When navigating, the compass page displays the name of 

the location, the distance to the final destination, the speed of 

Introduction

1