Garmin International Inc A03110 Manuel D’Utilisation

See the Important Safety and Product Information guide in the 

product box for product warnings and other important 

information.

The camera requires a microSD

™

 or microSDHC memory card 

of up to 64GB with a speed rating of class 10 or higher. You can 

use the included memory card, or you can purchase a 

compatible replacement memory card from an electronics 

supplier.

Insert the memory card 

À

 into the slot 

Á

.

Press it in until it clicks.

Removing the memory card while the device is turned on can 

result in a loss of data or damage to the device.

Turn off the device.

Press the card in until it clicks.

Release the card.
The card ejects from the slot.

À

 

Press to turn the device on.
Hold for 3 seconds to turn the device off.
Select to return to the previous page.

Á

Select to scroll through menus or pages.

Â

Select to scroll through menus or pages.

Ã

 

From the viewfinder, select to save a photo.
Hold to save a video clip.
Select to choose an option in a menu.

The adhesive mount is extremely difficult to remove after it is 

installed. You should carefully consider the mounting location 

before you install the mount.
Before you can install the adhesive mount onto your windshield, 

the ambient temperature must be from 21° to 38°C (from 70° to 

100°F).

TIP: You can connect the device to power and hold the device in 

the preferred mounting location to check the camera's field of 

view at that location.

Clean the windshield using water or alcohol, and a lint-free 

cloth.
The windshield must be free of dust, wax, oils, or coatings.

Remove the protective film from the mount adhesive.

Position the mount over the mounting location.
TIP: The adhesive is extremely sticky. Do not touch the 

adhesive to the windshield until the mount is properly 

positioned and aligned.

Press the mount firmly onto the windshield, and maintain 

pressure for 30 seconds.

Pull the camera and mount away from the windshield.
The metal disk remains attached to the windshield.

Using your finger, press firmly on the disk for 30 seconds.
This helps to ensure the disc adhesive has proper contact 

with the windshield.

Wait 24 hours before installing the Dash Cam.
It takes 24 hours for the adhesive to bond properly to the 

windshield.

Before installing the Dash Cam, you must install the mount and 

allow the adhesive to bond to the windshield for 24 hours. 

Failure to allow adequate bonding time may cause the mount to 

detach from the windshield, which could result in damage to the 

product or mount.

Place the camera and mount onto the magnetic disc.

Plug the vehicle power cable into the USB port on the device.

Getting Started

1