Garmin International Inc A2784 Manuel D’Utilisation

• Contact your local waste disposal department to dispose of

the device/batteries in accordance with applicable local laws

and regulations.

Information about the Garmin product recycling program and

WEEE, RoHS, REACH, and other compliance programs can be

found at www.garmin.com/aboutGarmin/environment.
Declaration of Conformity

Hereby, Garmin declares that this product is in compliance with

the essential requirements and other relevant provisions of

Directive 1999/5/EC. To view the full Declaration of Conformity,

go to www.garmin.com/compliance.
Industry Canada Compliance

Category I radiocommunication devices comply with Industry

Canada Standard RSS-210. Category II radiocommunication

devices comply with Industry Canada Standard RSS-Gen. This

device complies with Industry Canada license-exempt RSS

standard(s). Operation is subject to the following two

conditions: (1) this device may not cause interference, and (2)

this device must accept any interference, including interference

that may cause undesired operation of the device.
Radio Frequency Radiation Exposure

This device is a mobile transmitter and receiver that uses an

internal antenna to send and receive low levels of radio

frequency (RF) energy for data communications. The device

emits RF energy below the published limits when operating in

its maximum output power mode and when used with Garmin

authorized accessories. To comply with RF exposure

compliance requirements, the device should be used as

described in the manual. The device should not be used in

other configurations. This device must not be co-located or

operated in conjunction with any other transmitter or antenna.
FCC Compliance

This device complies with part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) this device may

not cause harmful interference, and (2) this device must accept

any interference received, including interference that may

cause undesired operation.

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the

FCC rules. These limits are designed to provide reasonable

protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate

radio frequency energy and may cause harmful interference to

radio communications if not installed and used in accordance

with the instructions. However, there is no guarantee that

interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

3