Davis Instruments DWW765Y Manuel D’Utilisation
17
pressing the up arrow until “ON” displays on the screen. Change the station type by
pressing GRAPH until the correct station type displays.
pressing GRAPH until the correct station type displays.
2. Press WIND to turn the repeater function on and to display repeater ID information.
The first repeater ID displayed is Repeater A, which is the default.
3. Find the second transmitter ID, and if that station is not turn on with it’s station type
selected, do so now.
4. Press WIND to turn on the repeater function and display the repeater ID information
for that transmitter.
5. Continue selecting, turning on and enabling the repeater function for each transmitter
in the network.
6. Press DONE to continue to the other screens in the Setup Mode, or press and hold
DONE to return to the Current Weather Mode.
Note:
See the Vantage Pro2 console manual for more information on the screens in the Setup Mode if
necessary.
necessary.
To verify that setup was successful, in the console’s current mode:
1. View the transmitter information displaying at the bottom of the console screen.
If the transmitter ID being repeated is displayed and an “X” displays in the bottom
right-hand corner of the ticker tape, the transmitter is being repeated and received by
the console successfully.
right-hand corner of the ticker tape, the transmitter is being repeated and received by
the console successfully.
Combination Network (Multiple Transmitters/
Repeaters) Installation
Repeaters) Installation
A multiple transmitter, multiple repeater installation can take place any number of ways
with some repeaters receiving both repeaters and transmitters. See “Single Repeater
Installation” on page 8 for detailed instructions on configuring the transmitter and con-
sole for wireless repeater use.
with some repeaters receiving both repeaters and transmitters. See “Single Repeater
Installation” on page 8 for detailed instructions on configuring the transmitter and con-
sole for wireless repeater use.
This section covers the additional steps necessary to get a chain of repeaters set up and
communicating.
communicating.
Verifying/Changing Repeater IDs
A combination network installation requires that the first repeater, the repeater closest to
the first transmitter in the network, must have the repeater ID of A. The next repeater in
the chain must be programmed with the repeater ID of B. The repeater that is set to the
default of A is set up to only look for and acquire signals from the transmitters. The
repeater with ID B looks for a repeater with the repeater ID of A, and any transmitters it
is programmed to receive.
the first transmitter in the network, must have the repeater ID of A. The next repeater in
the chain must be programmed with the repeater ID of B. The repeater that is set to the
default of A is set up to only look for and acquire signals from the transmitters. The
repeater with ID B looks for a repeater with the repeater ID of A, and any transmitters it
is programmed to receive.
To set the repeater IDs for all of the repeaters in the network:
1. Identify the repeater that should be the first repeater in the network.
2