Charles Machine Works Inc The 752TKR Manuel D’Utilisation
750/752 Tracker - OPERATION
31
BEACON TRACKING MODES
750/752 Tracker - OPERATION
31
BEACON TRACKING MODES
Displayed Information
Beacons send a variety of information to tracker. All Ditch Witch
beacons send pitch, roll, temperature and battery information.
beacons send pitch, roll, temperature and battery information.
Roll
Beacon roll information is useful in determining the direction that
the drilling tool will tend to travel when pushed without rotation.
The following chart shows typical tool face roll indications for
directional drilling.
the drilling tool will tend to travel when pushed without rotation.
The following chart shows typical tool face roll indications for
directional drilling.
Depth
To estimate beacon depth, press depth button. Estimated depth
to beacon will be displayed. To change depth units, press depth
and mode buttons.
to beacon will be displayed. To change depth units, press depth
and mode buttons.
All tracking and locating systems are subject to interference. To
quickly check for interference, raise tracker 1’ (0.3 m) and make
second depth estimate. If the difference between the two
estimates is not 1’ (0.3 m), there is interference.
quickly check for interference, raise tracker 1’ (0.3 m) and make
second depth estimate. If the difference between the two
estimates is not 1’ (0.3 m), there is interference.
When beacon roll shows . . .
Drilling tool will move . . .
1 or 2 o’clock
up and right
3 o’clock
right
4 or 5 o’clock
down and right
6 o’clock
down
7 or 8 o’clock
down and left
9 o’clock
left
10 or 11 o’clock
up and left
12 o’clock
up
Displayed Information
Beacons send a variety of information to tracker. All Ditch Witch
beacons send pitch, roll, temperature and battery information.
beacons send pitch, roll, temperature and battery information.
Roll
Beacon roll information is useful in determining the direction that
the drilling tool will tend to travel when pushed without rotation.
The following chart shows typical tool face roll indications for
directional drilling.
the drilling tool will tend to travel when pushed without rotation.
The following chart shows typical tool face roll indications for
directional drilling.
Depth
To estimate beacon depth, press depth button. Estimated depth
to beacon will be displayed. To change depth units, press depth
and mode buttons.
to beacon will be displayed. To change depth units, press depth
and mode buttons.
All tracking and locating systems are subject to interference. To
quickly check for interference, raise tracker 1’ (0.3 m) and make
second depth estimate. If the difference between the two
estimates is not 1’ (0.3 m), there is interference.
quickly check for interference, raise tracker 1’ (0.3 m) and make
second depth estimate. If the difference between the two
estimates is not 1’ (0.3 m), there is interference.
When beacon roll shows . . .
Drilling tool will move . . .
1 or 2 o’clock
up and right
3 o’clock
right
4 or 5 o’clock
down and right
6 o’clock
down
7 or 8 o’clock
down and left
9 o’clock
left
10 or 11 o’clock
up and left
12 o’clock
up