Risco Ltd. CAV005 Manuel D’Utilisation

WatchIN Installation Manual

 

9

The Tamper spring S5 (Figure 7) should make contact with the wall through the tamper spring holes M2 
or M3 on the CSMA. Make sure to hear the tamper "Click" when connecting to the wall. 

7.  Insert tamper wires and external cable wiring from Standard Swivel through knockout W1 on 

the external base (Figure 7, Detail B). 

8.  Connect the external base to the swivel using the dedicated snaps (Figure 8). 

PCB

External Base

Internal Base

Angle Locking 

Screw

(See Note 2)

See Detail A

Swivel to External Base 

Connecting Screws

Detail A

Swivel Assy

Connecting Screw

(See Note)

Snaps

S1

W1

S2

S3

  

Figure 8 

Do not open or close the Swivel Assy Screw since it is used for connecting the swivel parts only. 

9.  Secure external base to swivel with two screws fastened to knockouts S1 and S2 (Figure 8). 

10. Insert the supplied angle locking screw from the external base through the angle locking screw 

knockout S3 on the external base to the standard swivel (Figure 8). 

11. Tilt and Rotate the Standard Swivel to the desired position. Once the Standard Swivel is in the 

desired position, secure the angle locking screw. 

12. Line up the internal base onto the external base. Insert all wiring cables through the internal 

base.  

13. Secure internal base to external base (Lock I1, Figure 2). 

14. To readjust the Standard Swivel when the PCB  is installed (Figure 9):  

a.  Bend down the black foam located below the RED LED on the PCB (enough to reach the 

Swivel locking screw).  

b.  Use a Philips screwdriver to release the locking screw (see Figure 9). 

c.  Tilt and/or Rotate the Standard Swivel to the desired position. 

d.  Secure the angle locking screw.