Risco Ltd. CAV005 Manuel D’Utilisation
WatchIN Installation Manual
6
LEDs Display
LED
State
Description
Steady
Indicates PIR detection
YELLOW
Flashing
Indicates AM (Anti mask) detection
GREEN
Steady
Indicates MW detection
Steady
Indicates ALARM
RED
Flashing
Indicates malfunctioned communication with ProSYS (BUS
mode only)
mode only)
All LEDs
Flashing (One after
another)
another)
Unit initialization on power up
Notes:
1. DIP-Switch 1 should be in ON position to enable LED indications.
2. Only one LED is active at any one time. For example, in the case of both PIR and MW detection, either the
2. Only one LED is active at any one time. For example, in the case of both PIR and MW detection, either the
steady YELLOW LED or the steady GREEN LED is displayed (the first to detect), followed by the Alarm RED
LED.
LED.
Relay Mode / BUS Mode Jumper
J-BUS jumper (located on the PCB between the red and green LEDs)
is used to define the detector’s mode of operation as follows:
is used to define the detector’s mode of operation as follows:
Relay
Mode
BUS
Mode