Graco Inc. CED1 Manuel D’Utilisation

1.

Press pin on top of corner finisher and install onto 
valve.

2.

Work from bottom to top of vertical angles and from 
one end to other on ceiling angles.

3.

Use drywall knife to detail corner and ceiling angle 
intersections.

1.

Install valve over two screws on box and tighten two 
wing nuts.

2.

Place flat box at end of joint.

3.

Lead with handle and draw the tool along the joint.

4.

Near middle of the joint, remove flat box from joint 
surface with a sweeping motion.

5.

Reverse hand positions and begin again at other 
end of joint.

6.

Again draw flat box along joint up to previous 
stopping point and remove box from joint surface 
with a sweeping motion.

7.

Use drywall knife to detail seams and overlap.

NOTE: Fine flow rate adjustments can be made using 
buttons on valve handle.

1.

Install trigger assembly and sanitary clamp.

2.

Insert pin into trigger assembly.